V90 L6-2.9L VIN 96 B6304S (1998)
4. Install new seal
-
Use drift tool No. 999 5449, or equivalent.
-
Grease seal.
-
Press in seal.
5. Remove rear seal
-
Remove camshaft position sensor and shutter.
-
Carefully pry out seal with screwdriver.
-
Clean seal seat and check shaft end for signs of wear.
6. Install new seal
-
Use drift tool No. 999 5450, or equivalent.
-
Grease seal.
-
Press in seal.
Seal is normally located in same plane as edge of inside shoulder. If shaft end is worn seal may be located a further 2 mm.
NOTE: Procedure steps 7-13 are omitted if replacing camshaft rear seals only.
7. Lock crankshaft