V90 L6-2.9L VIN 96 B6304S (1998)
12. Remove crankshaft seal
-
Pry out seal carefully using screwdriver, taking care to avoid damaging sealing faces on shaft and in seat.
-
Clean seat and inspect shaft for signs of wear.
13. Press seal into seat
-
Use handle tool No. 999 1801 and assembly tool No. 999 5430, or equivalents.
-
Oil mating surface between seat and seal. Oil lips of seal.
-
Place seal on tool.
-
Tap in seal until drift bottoms against crankshaft.
14. Install carrier plate
-
Use gear sector tool No. 999 5112, or equivalent.
-
Use new bolts and thread locking compound.
-
Tighten to 45 Nm (33 ft. lbs.).
-
Tighten through further 50 degrees.
15. Install transmission
-
Use fixture tool No. 9999 5972, or equivalent.
-
Tilt transmission slightly backwards while lifting.
-
Align torque converter with carrier plate.