V90 L6-2.9L VIN 96 B6304S (1998)
Connect cables from the new cable harness to the separated connectors.
G4
Location of cable sheath opening
The cable sheath is cut to drain off condensation.
-
The cut conduit section should be placed at the lowest point along the route of the cable.
-
Use butyl tape to seal the grommet.
-
Use existing cable tie to clamp cables to firewall.
G5
Connecting cable harness to heater
-
Disconnect the yellow and black connector from the power unit and attach the connectors from the cable harness.
-
Install the detached connectors in the other cable harness connectors.
-
Connect control module and cable harness connectors.
Connecting and installing the control module
G6
Connect to central electronics module
-
Route the black cable inside the centre console side panel to the central electrical unit.
-
Connect cable to central electronics module fuse 16 and terminal 3.
