V90 L6-2.9L VIN 96 B6304S (1998)
G7
Check airing cycle is working
-
Connect battery lead and start car.
-
Turn on A/C system to start compressor.
The A/C system starts if the temperature exceeds approx. 7°C (45°F).
-
Make up a cable (about 2 meters in length) to connect battery positive terminal to control module connector.
Connect to green cable, connector terminal 6, for at least 30 seconds while compressor is operating.
-
Turn off engine.
Airing cycle should begin after approximately 10 seconds and continue for approximately 1 second.
-
Remove cable between connector and battery.
G8
Fastening cables
-
Clamp cable harness in position using tie straps on the front of the air duct below glove compartment.
-
Use the eyelet on the connector to fasten the tie straps.
-
Clamp cable harness in position using the straps on the front of the air duct above glove compartment (not shown in illustration).
-
Use the eyelet on the connector to fasten the tie straps.
