V90 L6-2.9L VIN 96 B6304S (1998)
Transmission Position Switch/Sensor: Adjustments
Gear Position Sensor, Checking/Adjustment
Special tool: 999 5475
NOTE: First, check that control rod is correctly adjusted.
-
Unclip HO2S lead from transmission member and oil pan and open HO2S connectors.
-
Remove front exhaust pipe.
-
Remove front heat shield.
-
Ensure that gear selector lever is in neutral (position N)
-
Loosen sensor enough to turn it sideways. Mount gauge 999 5475 on gear selector shaft outside nut.
-
Turn sensor until mark on tool is opposite boss on sensor as illustrated.
-
Tighten adjusting screw to 13 Nm (10 ft lb).
-
Reconnect HO2S connectors. Secure wiring to transmission member and oil pan.
-
Erase DTCs (if any)
