V90 L6-2.9L VIN 96 B6304S (1998)
Control Arm: Service and Repair
Lower Link, Replacement
TOOL REQUIRED
-
999 5577 Compression Tool
-
Or Equivalent
REMOVAL
1. Raise The Car.
Position the rear lift arms so they do not obstruct the support arm and the support arm bracket of the vehicle.
2. Support Arm Removal As Follows:
-
Remove the wheels. Use of compression tool.
-
Install compression tool 999 5577.
Apply the compression tool lightly against the link.
-
Remove:
Lower screw on the damper.
Tap off damper from support arm.
Anti-roll bar screws on both sides.
-
Press anti-roll bar up so it is freed from the support arm.
3. Press Up Link To Normal Position:
-
Secure the compression tool with locking pin.
-
Release pressure from hydraulic cylinder.
-
Remove:
Support arm screws in front and rear edges.
Unscrew nut in front edge.
Tap support arm off the wheel bearing housing.
-
The nut in front edge.
-
Support arm.