XC60 AWD L6-3.2L VIN 96 B6324S2 (2010)
-
Remove the rubber grommet from the floor and place it to one side. It will not be reused.
-
Insert the cable with the connector into the hole in the spare wheel well.
Note! Install the rubber grommet so that the cable points to the left on the inside.
-
Clamp the cable harness at the radiated heat shield's left bracket using a cable tie from the kit. Install the clip in such a way that the cable harness
comes out from the sharp edge of the bracket. Do not tighten the cable tie yet.