XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
-
Take the cradle from the kit.
-
Drill out three holes, using a -6 mm (15/64") drill bit, in the center of the three central drill markings (in the recessed holes) in the middle of the
cradle.
-
Remove any swarf and clean the edges of the holes.
-
Drill six holes using -5 mm (13/64") drill bit, in the center of the six drill markings at the sides (in the recessed holes) on the cradle.
-
Remove any swarf and clean the edges of the holes.
Installation
-
Remove the two middle pieces of protective tape.