XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
-
Press the lower part of the panel towards the sill panel at the middle holes and drill through both using a - 5 mm (13/64") drill bit.
-
Remove any swarf.
-
Rivet the panel through the two holes.
-
Repeat drilling and riveting for the two rear holes.
-
Press the lower part of the panel towards the sill panel at the front holes.
-
Drill out the rear hole using a - 5 mm (13/64") drill bit and the front using a - 6 mm (15/64") drill bit.
Note! Drill through the middle of the oval hole.
-
Remove any swarf.
Illustrations A and B
