XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
Disconnect the drain hose.
Warning! Be prepared to collect escaping fluids.
999 7363 Hose See: Tools and Equipment/999 7363 Hose
Fill with 4l of oil. Use transmission fluid. Refer to: Lubrication transmission See: Specifications
Apply the parking brake. Move the gear selector lever to position P.
Start the engine and allow to idle.
Shift through all the positions between P and D on the gear selector. Stop for 2 seconds per position. Switch off when air bubbles are visible in the hose.
Fill with 2 liters of oil. Start the engine again and allow it to idle. Switch off when air bubbles are visible in the hose.
Fill with 2 liters of oil again. Start the engine and allow it to idle. Switch off when air bubbles are visible in the hose.
Install the drain hose for the oil cooler.
Remove the integrated level plug.
Top up with oil until it starts to run out of the transmission.
Install the level plug by hand.
Check the oil level. Refer to: Transmission oil level - checking, B6304T2, TF-80SC AWD See: Service and Repair/Procedures/Transmission Oil Level
- Checking Transmission oil level - checking, B6324S, TF-80SC AWD, B6324S, TF-80SC See: Service and Repair/Procedures/Transmission Oil Level
- Checking
Reset the counter when replacing the transmission.
