XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
-
Cut of the shaded section on the mounting plate as illustrated in figure B.
Applies to the XC90 up to and including model year -2006 (CH-327999), and S60/V70/S80
-
Assemble the front intake according to figure D.
Installing the front intake, applies to the XC90
Steps 8 - 10 applies to the XC90 up to and including model year -2006 (CH-327999)
-
Guide the front socket's cable in through the center hole, next furthest to the left in the grille.
-
Take a screw, washer and attaching plate from the kit and install the front socket. Push it as far to the left as possible and tighten it.
-
Pull the cable to the left, in through the rubber seal on the left-hand side of the radiator, continue down by the left front side, on the right-hand
side.
-
Remove the engine splash guard (1) by first removing the screws (2).
Steps 11- 23 apply to the XC90 from and including model year 2007- (CH 328000-)