XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
Thread the seal onto the beveled section of the inner section of tool 999 7174 Drift See: Tools and Equipment/999 7174 Drift with the felt side of the
seal outwards. Install the drift on the crankshaft, 2 x screws, for the flywheel. Pull in the seal using the outer section of the drift: 999 7174 Drift See:
Tools and Equipment/999 7174 Drift using the screw in the center of the tool. The seal is in position when the outer drift bottoms out against the inner
drift. Remove the tool:999 7174 Drift See: Tools and Equipment/999 7174 Drift. Discard the old screws for the flywheel.
Installing flywheel and carrier plate
Caution! Ensure that the surface of the crankshaft and the mating surfaces for the flywheel / carrier plate are clean. Ensure that there is no
thread sealant residue in the screw holes.
Install:
-
the flywheel and carrier plate
-
the 3 studs 999 5678 Special screw See: Tools and Equipment/999 5678 Special Screw distributed as illustrated. Turn the short thread length
towards the crankshaft.
Note! Check that the locating pin on the crankshaft is positioned opposite the hole in the flywheel / carrier plate. The position of the guide hole
is marked.
Caution! It is important that the flywheel and carrier plate bear on the crankshaft flange before the other screws are installed.Always use new
screws. Ensure that the thread sealant on the new screws is intact. If not apply a few drops of sealant 1161056 to the thread.
