XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
-
Unscrew the front clip.
-
Repeat the operation on the other side.
-
Turn the knob (1) on the right/left side 90°.
-
Fold the panels inwards. Lift the panels out
-
Remove the two covers (2) and the screws (3) underneath (applies to S80 only).
-
First pull the boot lid sill panel (4) forward until the two clips on the right/left side release. Pull hard but carefully as the panel is securely fastened.
Then pull the panel straight up until the four clips in the bottom edge release.
-
Remove the wiring (5) for the cargo compartment lighting.
-
Lift out the sill trim panel.
-
Take the wiring harness (1) from the kit. Position it along the boot lid sill with the black connector to the right, in the rear edge on the right wheel
housing.
-
Remove the ground screw (2) and connect the ground cable of the new wiring harness to the existing grounding point. Tighten the ground screw
securely.
-
Take five cable ties (3) from the kit and secure the wiring harness to the existing wiring harness as illustrated.
-
Remove the Rear Electronic Module (REM) by opening the lock (1) on the top of the unit. Tip the unit forward and lift it out of the mountings (2).
