XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
Note! When adjusting the gear-shift position sensor, press the tool down to the flat surfaces below the thread on the shaft.
Remove the lever. Install adjustment tool 999 5475 GAUGE See: Tools and Equipment/999 5475 Gauge on the gear shift linkage rod. Check that the
shaft is in the N position. The groove on the tool must align with the marking on the gear position sensor.
If adjustment is required, see the following procedure in this section.
Adjusting the gear-shift position sensor
Remove the nut for the cable duct. Lift the cable duct away from the screw.
Slacken off the screws for the gear-shift position sensor.
Rotate the gear position sensor so that the mark on the switch aligns with the groove on the tool. Tighten the screws for the sensor. Tighten to 25 Nm.
Remove the adjustment tool.
Installing the lever and gear selector cable
Install:
-
the lever on the gear shift linkage rod. Tighten to 16 Nm
-
the cable on the lever
-
the screws for the bracket. Tighten to 25 Nm.
Installing the air cleaner (ACL) housing
