XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
Accelerator Pedal Position Sensor: Description and Operation
Accelerator Pedal (AP) Position Sensor
The function of the accelerator pedal (AP) position sensor is to provide the engine control module (ECM) with information about the position of the
accelerator pedal. This data is used by the control module to deploy the shutter in the throttle unit to the correct angle.
The sensor consists of a plastic housing with two potentiometers, an Analog/Digital converter and circuits. The potentiometers are connected to a shaft
which is affected by the position of the accelerator pedal (AP). The resistance in the potentiometers changes with the position of the accelerator pedal
(AP).
The accelerator pedal (AP) position sensor transmits an analogue and a digital signal (pulse width modulated (PWM) signal) to the control module.
These signals indicate the position of the accelerator pedal (AP). The digital signal is generated by the sensors Analog/Digital converter.
The analog and digital signals are used at the same time by the control module to regulate the throttle shutter angle.
The sensor is supplied with 12 V by the system relay via a fuse and is grounded to the body.
The digital signal is also used in conjunction with the analogue signal for accelerator pedal (AP) position sensor diagnostics. The accelerator pedal (AP)
position sensor signals can be read using VADIS/VIDA. A diagnostic trouble code (DTC) is stored if the engine control module (ECM) detects a
difference between the analogue and digital signals. The engine control module (ECM) then uses a minimal value to ensure the function (limp home).
The accelerator pedal (AP) position sensor is located on the accelerator pedal bracket.
