XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
Remove all relays and shunts bridged to the control module. Note the locations.
Release the catch on the rear. Use a screwdriver.
Lift and pull out the control module.
Check
Check that the control module's connectors are intact.
Installing the control module
-
Press the control module into place so that the catch on the rear engages
-
Position the connector. Carefully press the connector down.
Note! The pins are fragile. Check that the connector goes straight down into the control module.
-
Tighten the screw for the connector
-
Check that the connector cover is correctly positioned. Remedy if necessary
-
Install the relays and shunts. Note their locations
-
Install the integrated relay / fusebox. See Installing the integrated relay / fusebox in the cargo compartment.
Ordering software
Order the software. See 9494723.
Replacing the Accessory Electronic Module
Replacing the accessory electronic module
Removal
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information is always correct.
Preparation