XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
Power Seat Control Module: Service and Repair
Front Seat, Driver's Seat, Front Seat
Power seat module (PSM), replacing
Removing the control module
Raise the seat to its highest position.
For first generation power seats:
Remove the seat from the car. See Lifting seats in and out See: Body and Frame/Seats/Service and Repair/Removal and Replacement.
For second generation power seats:
Remove the seat from the car. See Removing power seats, tilting See: Body and Frame/Seats/Service and Repair/Removal and Replacement.
Remove the key.
Note! The key must be removed to ensure that the ignition is not switched on by mistake.
Wait 1 minute before starting work.
Remove the two screws.
Disconnect the connector.
Remove the control module.
Installing the control module
Install:
-
the control module
-
the connector
-
the two screws. The seat must be tightened to the floor. Tighten to 48 Nm.
-
the key
-
for first generation seats, see Lifting seats in and out See: Body and Frame/Seats/Service and Repair/Removal and Replacement. For second
generation seats, see Removing power seats, tilting See: Body and Frame/Seats/Service and Repair/Removal and Replacement.
