XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
Read off the programmed values.
To change the time, mark the desired value in the scrolling list and start programming.
Do you want to program any more parameters?
Yes - Programming a long interior lighting period
No - Fault Found
------------------------
Programming a long interior lighting period
The general lighting and rear reading lamps light and remain lit for 10 minutes when:
-
A door is opened after being unlocked.
-
The lamp is lit with a switch.
The default period is 10 minutes. This can be changed to between 0 and 255 minutes at 10 minute intervals.
Read off the programmed values.
To change the time, mark the desired value in the scrolling list and start programming.
Continue - Fault Found
------------------------
FAULT FOUND - Checking the anti-dazzle function in the rear view mirror
-------------------------------------------------
Checking the anti-dazzle function in the rear view mirror
Checking the anti-dazzle function in the rear view mirror
Checking the anti-dazzle function
Note! If the upper electronic module (UEM) has been replaced software, specially developed for downloading after replacing the control
module, must be downloaded to the control module before the anti-dazzle function is changed. See Upper electronic module (UEM) rear view /
door mirror, replacing See: .
The rear view mirror anti-dazzle function can be adjusted:
-
If the rear view mirror anti-dazzle function is too powerful or too weak, it can be adjusted.
Specific software for setting the anti-dazzle function must be installed in the car to do this.
Order the software. See9499432.
Install the software. See9499432.
Continue - DONE
------------------------
DONE - DONE
-------------------------------------------------
