volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Relays and Modules - Starting and Charging > < SRS Connector|Page 772
Page 5
background image

Warning! The ignition must not be switched on when the SRS ignition cable connector is being removed or installed.

When all components have been installed:

-

switch ignition to position II

-

reconnect the battery negative lead.

Note! Check that the SRS indicator lamp is not defective by turning the key to position II. The SRS indicator lamp should light and go out after
approximately seven seconds.

-

Check that the SRS indicator lamp is not lit constantly. If the lamp is lit constantly use the data link connector (DLC) or VCT2000 to trace the
fault.

Relays and Modules - Starting and Charging > < SRS Connector|Page 772