XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
If the fuel tank is replaced, see next step.
-
Install the wire on the new ejector for the level sensor and pump
-
Insert the hoses and wiring into the tank via the right-hand tank hole
-
Grip the right-hand level sensor and pump holder and pinch it so that the float is held in its lowest position
-
Carefully and slowly lower the holder. Carefully work the holder into place
-
Pull the wire so that the hoses and wiring end up on the left side of the tank
-
Install the left-hand level sensor on the ejector
-
Install the switches on the underneath of the left-hand level sensor
-
Remove the wire from the ejector.
Cable routing when replacing the fuel tank
If replacing the fuel tank, wire cannot be used.
The image shows how to route the fuel lines and electrical wiring in the tank. Use a plastic pipe at least 1.7 m long.
Hint: Use spare part plastic pipe between the carbon filter and EVAP valve.
Insert the hose through the hole for the level sensor on the left-hand side of the vehicle and press it through the tank and take the end of the hose through
the hole for the fuel pump.
