XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
-
Lubricate the O-rings for the cable harness grommet and the oil temperature sensor with automatic transmission fluid.
Install:
-
the cable harness. Connect the connectors to the solenoids
-
the oil temperature sensor with the holder and screw. Tighten to 10 Nm
-
the cable harness on the holder. Check that the cable harness is correctly positioned.
Sealing the cover
-
Check that the mating surface for the cover is level.
-
Wipe the cleaned mating surfaces on the cover and transmission. Use denatured alcohol.
NOTE: Ensure that no dirt gets into the transmission.
-
Apply a bead of sealing compound, approximately 3 mm thick, to the cover. P/N 1161409 6. Apply the compound around the screw holes.
Installing the control system cover
-
Reinstall the control system cover on the transmission. Tighten the screws alternately. Tighten to 12 Nm. Torx TX 40.
-
Stretch the cable up to the oil temperature sensor.
Install: