XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
-
the oil pipe on the transmission with a new O-ring
-
the return line to the control system cover
-
the cable harness to the holder on the cover
-
the ground lead for the transmission.
Installing the sub-frame
-
Position the mobile jack998 5972 under the left-hand side of the sub-frame.
-
Press the frame up against the car body. At the same time locate the ball joint on the control arm and the steering gear screws to the frame.
-
Install new screws (M14) on the sub-frame. Lubricate the threads. Tighten the screws.
-
Tighten to 105 Nm. Install the support plate screws at the same time.
Installing components in the steering gear and sub-frame
Install:
-
new lock nuts and screws on the steering gear. Tighten to 50 Nm
-
the screw for the front engine pad. Tighten to 50 Nm
-
new screws for the torque rod mounting. Tighten to 35 Nm and angle tighten +40°.
-
Press the power steering line into the holders on the sub-frame.
Installing the nuts securing the ball joint to the control arm and the anti-roll bar to the link rods