XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
-
Install the nuts for the ball joint and control arm: Counterhold with a Torx wrench so that the boot does not rotate. Tighten to 80 Nm.
-
Install the anti-roll bar and link rods: Use new nuts. Tighten to 50 Nm.
-
Install the cross member.
-
Ensure that the brake pipe is pressed into place in its holder.
-
Tighten the member. Tighten to 25 Nm.
Installing the screw for the drive shaft
-
Use a new screw. Tighten to 50 Nm.
-
Clean the ABS sensor seat. Install the sensor on the wheel spindle. Tighten to 10 Nm.
Installing components on the sub-frame
Install: