XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
Make up two centering sleeves which are then positioned on the rear mountings for the sub-frame. This will make it easier to center the rear
suspension.
The measurements of the centering sleeves:
A = 20 mm
B = 13 mm
C = 50 mm
Place the sub-frame on a lifting table.
Raise the sub-frame so that it is approximately 15 cm from the bodywork.
If the vehicle is equipped with Four-C (Continuously Controlled Chassis Concept), install the cable harness on the sub-frame.
All cars:
Install the 3 connections on the EVAP canister. Lift the sub-frame up completely to the bodywork.
Note: Ensure that the brake pipes are not crimped at the subframe mountings.
Install the 3 connections on the EVAP canister.
Lift the sub-frame up completely to the bodywork.
