volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Reading and Clearing Diagnostic Trouble Codes|Page 14320 > < Reading and Clearing Diagnostic Trouble Codes|Page 14318
Page 2
background image

Counter, high temperature

Indicates number of times the High Level Display Front (HLDF) has been switched off due to a too high internal temperature.
Measurement range 0 to 65535.

Description of Frozen Values, HLDF

Description of frozen values

Explanation

Frozen values are parameter values that are stored when a diagnostic trouble code (DTC) is stored.
Not all parameters can be read out for all diagnostic trouble codes. The parameter values can only be read if they can provide additional information on
the prevailing conditions when the code was generated.

Total mileage, value

Measurement range: 0-1,000,000 km
The value indicates the vehicle's total mileage when the Diagnostic Trouble Code (DTC) was generated.

MECU power supply, value

Measurement range: 0-63 V
Normal range: 12.0-14.5 V
The value indicates the power supply to the central electronic module (CEM) when the diagnostic trouble code was generated.

Passenger compartment temperature, value

Measurement range: -40 till +215 °C
The value indicates the passenger compartment temperature when the diagnostic trouble code was generated.

Outside temperature, value

Measurement range: -40 till +215 °C
The value indicates the outside temperature when the diagnostic trouble code was generated.

Power supply mode, status

The value indicates the status of the power supply mode when the diagnostic trouble code was generated.
Key removed
Key recently removed
Key approved
Ignition off after Accessory position
Accessory position
Accessory position after Ignition on
Ignition on
Running
Start attempt
Signal missing

Active signal source, status

Indicates which signal source is active.
RGB = RGB input. Normally always connected to the multimedia module (MMM).
Video 1 = Video input 1, composite video signal input.
Video 2 = Video input 2, composite video signal input.

Power supply, HLDF, value

Measurement range: 6-20 V
Indicates the power supply to the high level display front (HLDF).
The normal value when the alternator is charging: 13.0-14.5 V.

Internal temperature, value

Reading and Clearing Diagnostic Trouble Codes|Page 14320 > < Reading and Clearing Diagnostic Trouble Codes|Page 14318