XC70 AWD L6-3.2L VIN 98 B6324S (2009)
-
Thoroughly clean away splashes of underseal, putty or dirt from the plate surfaces on the insides of the side members where the reinforcements
shall be located.
Installing the towing member
-
Check that the contact surfaces inside the side members are clean, if not, clean them opposite where the towing member's side plates shall be
tightened.
-
Take the towing member from the kit and insert the two side plates in the holes in the rear edge of the side members.
-
Take the screws and reinforcement bar from the kit. Request the assistance of a colleague and adjust the position of the tow bar as the screws enter
the welded nuts of the tow bar.
Note! Ensure that the reinforcement bar is correctly positioned (see small image).
Hint: The silencer must be moved downwards for the screws and reinforcement bar to be installed and tightened correctly.
-
Tighten the screws alternately on both sides.
Tightening the screw joint
