XC70 AWD L6-3.2L VIN 98 B6324S (2009)
Illustration A
-
Remove the four screws on both sides.
Illustration B
-
Place the fender liner to one side. Remove the screw at the upper edge of the cover on both sides.
-
Carefully pull of the ends of the bumper cover from the body on both sides. They are attached with hooks at the upper edge of the ends and at the
lower edge of the tail lights.
-
Pull the bumper cover away from the body, it is secured by seven guides at the upper edge of the longer side.
If the car is equipped with rear parking assistance, disconnect the connector on the right-hand side of it.
Note! To prevent damaging the bumper cover, it is recommended to request the assistance of a colleague during this procedure.
-
Place the bumper cover on a suitable surface.
Applies to the XC70
