XC70 AWD L6-3.2L VIN 98 B6324S (2009)
Cutting out the bumper cover
Illustration A applies to the V70
Illustration B applies to the XC70
-
Apply tape to the outside of the bumper cover, opposite the markings on the inside. This is done to protect the paint from the saw when cutting out
the cut-out for the towbar.
-
Cut according to the markings.
Note! Do not damage the painted surface of the bumper cover. Cut so that the raised edge on the inside remains. The raised edge marks
the cut-out.
-
Remove the tape.
-
Smooth off the sawn edges with a fine toothed file.
-
Install the tow hitch connector with cable harness according to the appropriate installation instructions.
Applies to the V70 with R-design
