XC70 AWD L6-3.2L VIN 98 B6324S (2009)
-
Clean the boot lid at the markings where the spoiler's feet are to be positioned. Use isopropanol and then wipe dry. Compare the surface with the
spoiler's feet so that the surface is sufficiently cleaned.
-
Remove the protective film from the tape on both feet of the spoiler.
-
Request the assistance of a colleague and align the spoiler's studs in the drilled holes on both sides.
-
Lower the spoiler to the boot lid, but not so the tape adheres.
-
Check that the play between the spoiler and boot lid is the same on both sides, and that the holes on the inside of the boot lid correspond with the
holes and studs in the spoiler.
-
Press the spoiler towards the boot lid so that the tape adheres properly around the spoiler feet (otherwise there is a risk that the tape will detach
when installing the screws/nuts).
