XC70 AWD L6-3.2L VIN 98 B6324S (2009)
Early Design
How To Use The Wiring Diagrams
A. Component designation
Every component has a component designation that consists of two parts.
The first part is a type number that describes the type of component in question, for example 3/xx.
The second part of the designation is a serial number, e.g. x/2.
Together, this constitutes a component designation, e.g. 3/2.
At the end, list of components, where, with the help of the component designation, you can read off the name of the component, for example, 3/2 = light
switch.
List of type numbers
The list shows which type of component that respective type numbers refer to, for example, 3/x = switch, 6/x = electric motor, etc.
1
Battery
2
Relay
3
Switch
4
Control module
5
Driver Information Module
6
Electric motor
7
Sensor
8
Actuator
9
Heating element
10
Light
11
Fuse
15
Electrical distribution rail/box
16
Audio
17
Service/diagnostics
18
Contact reel
19
Meter
20
Ignition component/shunt
27
Optics
31
Ground connection
73
Branching point
74
Connector
B. Branching points
The wiring diagrams contain numbered branching points, for example 73/5035.
The information contains a section with a list of branching points. This list shows all the components that are connected to each branching point.
The location of the branching points is shown in the "Cable harness routing in vehicle" section.