XC70 AWD L6-3.2L VIN 98 B6324S (2009)
Finishing
Securing the cable for the SRS system
Secure the new cable for the SRS system next to the old cable using a tie strap or similar. Reinstall the connectors.
Installing the battery lead
Fit the battery's negative cable in accordance with:.
Checking and adjusting the SRS system
Turn the ignition to position 2.
Check the SRS system to ensure that the warning lamp comes on and stays on while the SRS system performs a self-test. The lamp must go out after a
few seconds. If not, perform fault-tracing according to VIDA vehicle communication.
If everything is working, reinstall other components.
Test drive the vehicle.
Diagnostic Instructions - Fibre Optic Cable
Diagnostic Instructions - Fibre Optic Cable
Check
Note! Check that special tool 951 2867 MOST instrumentation See: Tools and Equipment/951 2867 MOST Instrumentation is working before
using it. This is carried out as follows.
-
Select the desired socket for connection by setting the SELECTOR SWITCH to position 2+0 or 2+4
-
Connect a suitable optical test cable, with the instrument supplied, to the selected socket
-
Select visual indication (green lamp - LED) or sound indication (buzzer - BEEP) by setting the right-hand BEEP/LED switch to the desired
position
-
Set the OFF/ON switch on the special tool to ON. The red POWER ON lamp must light.
-
Press the red button (2+0 TEST or 2+4 TEST) on the lower section of the special tool which corresponds to a connected test cable. The unit now
transmits a light signal through the test cable
-
The transmitted signal will be received as long as there is now a complete optical loop. If visual indication is selected, the green lamp (Rx) will
