XC70 AWD L6-3.2L VIN 98 B6324S (2009)
-
Take the cable harness for the sensors from the kit. Route the 2-pin connector from the inside and out through the hole on the outside of the fog
lamp.
Repeat the operation on the other side.
Note! On left-hand drive cars the large gray connector must be on the right-hand side. On right-hand drive cars it must be on the left-hand
side.
-
Plug in the connector to the sensor.
-
Install the panel on the bumper cover.
-
Repeat the operation on the other side.
Part 2
Parking assistance, front (Continued)
Applies to cars with headlamp washing
-
Remove the cable harness clips from the grille.