XC70 AWD L6-3.2L VIN 98 B6324S (2009)
-
Take the short cable harness from the kit.
-
Remove the taped connector from the cable.
-
Install the large connector to the cable harness from the sensors.
Applies to left-hand drive cars
-
Route the cable harness on the outside of the side member, up to the headlamp.
-
Secure the connector using two tie straps at the existing cable harness.
-
Lower the car.
Applies to right-hand drive cars
-
Route the cable harness on the outside of the side member, up to the headlamp.
-
Secure the connector using two tie straps at the cable holder (the clip) on the cable harness from the sensors.
-
Lower the car.
Steps 41-45 apply to left-hand drive cars