XC70 AWD L6-3.2L VIN 98 B6324S (2009)
-
Locate the four markings at the lower edge of the bumper cover. Make a mark in the middle using a scriber.
-
Drill at the markings using a -3 mm (1/8") drill bit. Drill from the inside of the bumper cover.
-
Drill out the holes. Use a -10 mm (13/32") diameter drill bit.
-
Enlarge the holes in the bumper casing using hole cutter part no. 9997234. Place the hole tool's support sleeve on the inside, and the cutting part
on the outside of the bumper casing.