XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Press the center of the clip at the lower edge/side of the bumper and remove it.
-
Remove the screw in the rear/top edge of the bumper cover.
-
Repeat the operation on the other side.
-
Carefully pull away the end face of the bumper cover from the body. It is fitted with four catches on the inside in the top edge and two in the
bottom edge.
-
Repeat the operation on the other side.
-
Pull the bumper cover forwards, detach the connectors for the fog lamps if fitted.
Assembling the front intake
Applies to the V70, and S80 up to and including model year -2003 (CH -334999)
-
Cut off the shaded sections on the mounting plates as illustrated in figures A and C.
Applies to the S80 from model year 2003- (CH 335000-)
-
Cut of the shaded section on the mounting plate as illustrated in figure B.
Applies to the XC90 up to and including model year -2006 (CH-327999), and S60/V70/S80
-
Assemble the front intake according to figure D.
Installing the front intake, applies to the XC90
Steps 8 - 10 applies to the XC90 up to and including model year -2006 (CH-327999)
