XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Remove the rubber grommet on the cable for the passenger compartment connector socket.
-
Cut the top off the large rubber cap on the recently routed rubber grommet for the cable harness
-
Apply low temperature grease (P/N 1161417-9) to the rubber grommet to facilitate routing the cable to the passenger compartment connector
socket
-
Insert the cable for the passenger compartment connector socket. Insert the cable through the rubber grommet.
-
Insert the cable for the passenger compartment connector socket and the single cable into the passenger compartment.
-
Route both cables to the front edge of the sill on the right-hand front door
-
Continue to route the single cable along the right-hand side of the car inside the floor carpets and insulation. Route the single cable to the
accessory electronic module (AEM) located on the right-hand side in the cargo compartment rear wheel well. Ensure that the single cable is
positioned so that there is no risk of it catching or rubbing
-
Secure at the cable duct in the cargo compartment. Use the three tie straps (1) from the kit.