XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Position the wiring and relay on the under side of the plate (1). Position the relay with the side against the plate to release the switch
-
Take a screw, washer and nut (2) from the kit. Tighten the relay to the plate
-
Secure the cable for the front engine block heater socket at point (3) in the plastic lug for the bumper cover mounting
-
Insert the thin cable together with the ground lead from the relay in the same position as the wiring for the engine block heater /passenger
compartment connector socket
-
Secure all wiring at point (4). Use a tie strap from the kit.
-
Remove the right-hand side panel from the centre console. Pull off the panel starting at the front edge. Then pull backwards until all the clips
release
-
Remove the right-hand side soundproofing panel. First remove the two screws. Then pry off the panel at the top edge.
-
Remove the panel on the right rear mounting on the right-hand front seat. Pry it up slightly at the rear edge and then pull it back / upwards.