XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Reinstall the engine splash guard. Tighten the screws. Tighten to 25 Nm (18 lbf.ft.)
-
Connect the connector to the headlamp. Reinstall the headlamp. Ensure that the headlamp lock pins are correctly positioned: The short innermost
and the long wide outside pins.
-
Insert the cable harness between the carpet and the door sill towards the floor as far as it will go. Route it along the right-hand side of the car up to
the opening for the right-hand rear door
-
Pull the cable up to the right-hand seat mounting on the right-hand seat in the second row of seats
-
Pull away the carpet from the front edge of the right-hand side panel in the cargo compartment
-
Route the cable to the right-hand side of the air duct towards the front edge of the rear wheel arch. Clamp the cable at the air duct. Use two tie
straps (1) from the kit
-
Route the cable along the reverse of the air duct and out along the front edge of the wheel arch.
Applies to cars with three rows of seats Illustration A
-
Insert a cable (1) at the rear edge of the right-hand side panel and along the inside of the panel, above the mountings for the load securing eyelets
and to the front edge of the side panel.
Illustration B
