XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Tape the cable harness (2) to the wire and pull it out of the rear edge of the side panel.
Applies to cars with two rows of seats
-
Route the cable along the left-hand side of the seat belt mounting at the front edge of the wheel arch. Route the cable inside the carpet at the front
edge of the side panel, between the side panel and the cargo floor support, to the accessory electronic module (AEM).
-
Remove the two screws from the bracket for the accessory electronic module (AEM) and lift up the entire unit. Cut off the tie straps if necessary.
