volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Removal and Replacement|Page 2779 > < Removal and Replacement|Page 2777
Page 5
background image

The thermostat can be tested in warm water.
Maximum opening must occur within 2 minutes in water at opening temperature.
Marking.90° C
Starts to open at.90°C
Fully open at.105°C

Belt Transmission, Assembly

Belt transmission, assembly

Special tools:

999 5747 Socket See: Tools and Equipment/999 5747 Socket 

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information in the illustrations is always correct.

Tightening torque

For tightening torques not in the text, see Tightening torque See: Engine, Cooling and Exhaust/Engine/Specifications/Mechanical
Specifications/Tightening Torque.

Installing the water pump

Install the rear timing cover.
Screw into place at the three mounting points.
Install the water pump with a new gasket.
Apply thread sealant, P/N 11-61 056, to all the screws for the water pump. Tighten crosswise.

Installing the oil pump

Use a new gasket and a new O-ring around the oil pump housing.
Screw sliding sleeve 999 5747 into place at the front of the crankshaft journal.

Removal and Replacement|Page 2779 > < Removal and Replacement|Page 2777