XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Check
Check that the control module's connectors are intact.
Installing the control module
-
Press the control module into place so that the catch on the rear engages
-
Position the connector. Carefully press the connector down.
Note! The pins are fragile. Check that the connector goes straight down into the control module.
-
Tighten the screw for the connector
-
Check that the connector cover is correctly positioned. Remedy if necessary
-
Install the relays and shunts. Note their locations
-
Install the integrated relay/fusebox. See Installing the integrated relay/fusebox in the cargo compartment.
Ordering software
Order the software. See: Testing and Inspection/Programming and Relearning/Software Downloading
Interior Lighting and Upper Electronic Module (UEM), Replacing
Interior lighting and upper electronic module (UEM), replacing
Replacing the lens and the bulb
Removal
-
Fold down the cover. See illustration.
-
Press the catches outwards. Remove the lens.
-
Remove the bulb. Use a weatherstrip tool or similar.
Replacing the lens and the bulb
Installation
-
Install the bulb.
