XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Caution! Tighten to the correct torque. If the knock sensor is over-tightened it may deform. If it is too loose it may disrupt the function of the
sensor.
-
Install the new sensors using the screws in the cylinder block
-
Route the cables on the outside of the starter motor bracket
-
Align the sensors (looking from the front)
-
The cable from the sensor at cylinder 3 = 3 o'clock and from the sensor for cylinder 5 = 6 o'clock
-
Tighten the knock sensors. See Tightening torque See: Engine, Cooling and Exhaust/Engine/Specifications/Mechanical Specifications/Tightening
Torque
-
Press the knock sensor (KS) connectors together. Check that the wiring is in the correct position. Use a clamp if necessary.
Install the intake manifold according to Intake pipe/gasket, replacement See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair.
Connect the battery lead. See Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting.
