volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

All Other Service Bulletins for Wheel Speed Sensor: > < Recall - Wheel Speed Sensor Replacement|Page 1849
Page 6
background image

Installing the air cleaner (ACL) housing

10

Install the air cleaner (ACL) housing. Check that the hoses are not trapped under the air cleaner (ACL) housing.

Install:

-

the plastic nut on the wheel arch side

-

the inlet hose using the hose clamp (2)

-

the connector (3)

-

the cable using the new cable tie to the air cleaner (ACL) housing

-

the turbocharger (TC) control valve on the air cleaner (ACL) housing

-

the inlet hose using the screws (1).

Function testing after replacement

11

Read off any diagnostic trouble codes (DTCs).

Erase diagnostic trouble codes (DTCs).

Switch off the ignition.

Start the engine. Check that the stop (brake) warning lamp does not light.

If the stop (brake) warning lamp lights, the car must not be driven.

Use VADIS and ensure that the system is free of DTCs.

Test driving

12

Drive the car at a speed above 30 mph (50 km/h).

Brake several times on an even, dry road surface from a speed above 30 mph (50 km/h) to stop. At least one braking must activate the ABS function.

Check that the stop (brake) warning lamp does not light.

All Other Service Bulletins for Wheel Speed Sensor: > < Recall - Wheel Speed Sensor Replacement|Page 1849