XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
-
Disconnect the large connector from the accessory electronic module (AEM). First press in the catch (A). Pull the black locking handle (B) in the
direction of the arrow until a click is heard. Disconnect the connector
-
Disconnect the connector from the accessory electronic module.
-
Remove the black catch holding the black switch in place in the connector by pulling in the direction of the arrow
-
Remove the black switch. Insert a pointed object in the hole on the other end of the connector. Press the switch out.
-
Connect the pre routed cable to terminal 5 in the accessory electronic module (AEM) connector.
Note! The numerical markings can be found on the top and bottom of the connector. However, the markings are extremely small so be careful
when installing the cable.
-
Reinstall the black switch in the connector. Lock into place using the catch
-
Press the connector into the accessory electronic module (AEM). Secure using the black locking handle
-
Reinstall the accessory electronic module (AEM) and the bracket and clamp the wiring with the tie strap from the kit
-
Reinstall the folding panel on the right-hand side in the cargo compartment
-
Reinstall the right-hand side floor hatch
-
Reinstall the storage boxes
-
Reinstall the rear floor hatch(es)
