XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
Install
-
the starter motor
-
the plastic nuts for the cover in the wing liner
-
the right front wheel. See Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair.
Install
-
the trigger wheel.
Note! Make sure that the trigger wheel is correctly positioned against the camshaft.
-
the camshaft position (CMP) sensor housing
-
the cover at the rear of the exhaust camshaft
-
the screws holding both the ground strips from the bulkhead to the cylinder head
-
the upper engine stabilizer brace
-
the cover over the ignition coils
-
the upper timing cover
-
the crankcase ventilation hose on the inlet hose
-
the inlet hose between the air cleaner (ACL) and throttle body (TB)
-
the engine stabilizer brace between the suspension turrets. Secure the servo hose at the right mounting for the engine stabilizer brace in the
bodywork
-
the cable to the battery negative terminal. Also read Battery, disconnecting See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery, Disconnecting.
Check
Check the level in the expansion tank and the brake fluid reservoir.
Test drive the engine until the thermostat opens and check for any leakage.
