XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
Caution! When cleaning work around the flange, not in and out. No grinding tools or similar may be used. It is extremely important that there
is no thread sealant residue or other dirt. This could cause leakage.
Note! To clean the crankshaft, use cloth 9511024.
Installation
Installing the sealing ring
Caution! Only Volvo approved engine oil may be used. Grease must not be used at all. It attracts dirt and results in the build up of coke.
Lubricate the sealing ring mating surface against the cylinder block and the lips of the seal.
Thread the seal onto the bevelled part of the inner section of 999 7174 Drift See: Tools and Equipment/999 7174 Drift with the felt side of the seal
outward.
Screw the drift onto the crankshaft (2 screws) of the flywheel.
Pull in the seal with the outer part of the drift, 999 7174 Drift See: Tools and Equipment/999 7174 Drift , using the screw in the center of the tool. The
seal is in place when the outer drift bottoms against the inner drift. Remove tool 999 7174 Drift See: Tools and Equipment/999 7174 Drift. Scrap the old
flywheel screws.