XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
Warning! The Supplemental Restraint System Module (SRS) for the XC90 has a new function, ROP (Roll Over Protection). The control
module must not be removed, moved to another position or worked on unless the power supply to it is cut. If the power supply is not cut the
airbags and seat belt tensioners may deploy.
The Supplemental Restraint System Module (SRS) is located between the parking brake and the gear selector lever in the center console.
Note! Never install car accessories on or near the Supplemental Restraint System Module (SRS).
8. Other SRS components
Wiring:
The SRS wiring is orange.
When working on SRS wiring, extra care must be taken to avoid damage to the following areas:
-
the soundproofing panels
-
the glove compartment
-
the dashboard
-
the steering shaft covers
-
the ignition switch
-
the sills
-
The panels for the A, B, C and D posts
-
the roof
-
below the headlamps.
Sensor:
The collision sensors for the SRS system (six + one) are in the B and C posts, under the headlamps and in the Supplemental Restraint System Module
(SRS).
The collision sensors control the SRS system.
Note! Never install car accessories on or near the Supplemental Restraint System Module (SRS).
Data Link Connector (DLC):
The data link connector (DLC) is in the passenger compartment.
Decals:
Safety decals must always be in the car at the relevant points. For further information see:
-
Decals for safety equipment (USA)
-
(rest of the world).
