XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
request, may result in warranty claim denial by Volvo.
Service
TEST DRIVE NOTES:
The test drive should be done as follows: Accelerate rapidly up to 50 mph, noting how the car behaves during acceleration. Then hold the car at 50 mph
long enough to note how it behaves during steady driving.
Then place the transmission in neutral and let the car freewheel, carefully noting how the car behaves the instant you put the gear in neutral: do the side
forces reduce or disappear, or are they the same?
Vehicles always have a tendency to veer towards the edge of a crowned road. This tendency will make the car pull towards the side when driving in the
"normal" traffic lane. To verify if there is a fault in the car, drive it on a perfectly flat road, or on a road which is crowned in the other direction. This
might best be accomplished on a multi-lane road which has road crowns in both the left lane (to the left) and right lane (to the right).
Warranty Claim Information
Technical Service Bulletin # TNN59-12
Date: 040217
Steering/Suspension - BCM Codes 0121 & 0127
NO: 59-12
DATE: 2-17-2004
MODEL: S60, V70, XC7O, S80, XC9O
M. YEAR: 2002 -
CHASSIS: All
SUBJECT: BCM code 0121 & 0127
REFERENCE: VADIS
DESCRIPTION:
On Vehicles with DSTC, under certain conditions BCM code 0121 or 0127 could be stored if the wheel alignment is out of specification.
SERVICE:
After all of the normal fault tracing has been performed. The wheel alignment should be checked and adjusted prior to replacing components if either
BCM 0121 or 0127 are stored. If the rear toe is found to be out of specification, please ensure that the inner and outer rear toe bar bolts are properly
torqued.
Technical Service Bulletin # TNN59-12
Date: 040217
Steering/Suspension - BCM Codes 0121 & 0127
NO: 59-12
DATE: 2-17-2004
MODEL: S60, V70, XC7O, S80, XC9O
M. YEAR: 2002 -
CHASSIS: All
SUBJECT: BCM code 0121 & 0127
REFERENCE: VADIS
DESCRIPTION:
On Vehicles with DSTC, under certain conditions BCM code 0121 or 0127 could be stored if the wheel alignment is out of specification.
SERVICE:
After all of the normal fault tracing has been performed. The wheel alignment should be checked and adjusted prior to replacing components if either
BCM 0121 or 0127 are stored. If the rear toe is found to be out of specification, please ensure that the inner and outer rear toe bar bolts are properly
torqued.
Technical Service Bulletin # TNN60-10
Date: 071025
