XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
Installing pipes for the expansion valve - junction block on the side member
Position the refrigerant pipe against the firewall.
Install the front section of the pipe.
Note! Use new O-rings lubricated with compressor oil.
Install:
-
the pipe on the member at the pipe connection using 1 M8 screw. Tighten
-
the hose / pipe from the member to the compressor
-
the pipe lock on the pipe holder
-
the pipe on the expansion valve using 1 M6 screw. Tighten
-
the heat shield for the expansion valve
-
the drainage channel and the plastic nut
-
the clamp for the refrigerant pipe
-
the outlet air pipe
-
the expansion tank
-
the connector at the cable duct
-
the switch for the level sensor
-
the hose on the expansion valve
-
the servo oil reservoir
-
the engine stabilizer brace in the engine compartment.
Carry out finishing work. See Finishing work (operations common to all methods).
Pipes receiver drier - expansion valve, replacing
Removing pipes from the receiver drier pipe - expansion valve