XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
-
Remove the tie straps from the cables
-
Disconnect the connector by releasing the locks on the front edge
-
Pull out and remove the connector.
Installation
Note! For tightening torques, see Specifications See: Specifications/Mechanical Specifications/Starting and Charging/System Specifications.
Installing the connector
Press the connector into the holder.
Central electrical unit, installing
Install:
-
the tie straps for the cables
-
the bottom section. Hook into place at the front edge
-
the screw in the rear edge. Tighten
-
the connector holder. Press into the catch.
Note! The rubber grommet
-
the screws
-
the engine cooling fan (FC) if applicable
-
the intermediate section. Check that all 3 clips have engaged.
Finishing work
Install:
-
engine control module (ECM) Engine control module (ECM), replacing See: Engine Control Module/Service and Repair and transmission control
module (TCM) Transmission control module (TCM), replacing See: Relays and Modules - Transmission and Drivetrain/Relays and Modules -
A/T/Control Module/Service and Repair
-
the cover for the central electrical unit
-
the battery negative pole. Also see Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting.
